Ⅰ. Preparations before the twin screw extruder starts up (works)1. Plastics for extrusion molding. The raw materials should meet the required drying requirements. Further drying is required if necess...
1. Precautions for the use of twin screw extruderThe circulating water of the cooling system of the twin screw extruder barrel should use distilled water or demineralized water. Be sure to use water f...
The twin screw extruder is developed on the basis of the single screw extruder. Due to its good feeding performance, mixing and plasticizing performance, exhaust performance, extrusion stability and o...
1. The reason why the main motor of the twin screw extruder cannot be startedThe start-up procedure is wrong. There is a problem with the main motor thread. Check whether the fuse is burned out.Treatm...
1. The damageable parts of the co-rotating parallel twin screw extruderIf there are fillers such as calcium carbonate and glass fiber in the material produced by the crusher, it may accelerate the wea...
In the production process of the twin screw extruder, if you want it to complete the production work normally, you need to pay attention to many aspects to avoid the three faults including the instabi...
1. Rinse the cooling water channel with acid for the twin screw extruderThe water-cooled twin screw extruder barrel is a heat exchanger. Like all heat exchangers, the water channel is prone to scaling...
1. Add a thermal insulation gasket between the feeding section of the twin screw extruder and the flange of the second sectionThe feeding section of the barrel is mostly water-cooled, which is locked ...
The twin screw extruder is developed on the basis of the single screw extruder. Due to its good feeding performance, mixing and plasticizing performance, exhaust performance, extrusion stability, and ...
Tel: +86-25-52706155
E-mail: info@kymach.com
No.59 West Tianyuan Road, Jiangning, Nanjing, Jiangsu Province, China
English 
日本語 
한국어 
français 
Español 
русский 
português 
العربية 
中文
